Stübben Steeltec Double Broken 3-Ring Bit Sweet Copper

• the 3-Ring Bit (double broken) offers an adjustable leverage effect depending on the rein position
• the rider can vary the pressure on the mouth and poll to achieve the desired control
• the double jointed mouthpiece distributes the pressure evenly over the tongue and bars

Note: Any bit can cause pain if used roughly or improperly. The wrong size can also be painful for the horse.

Material

• 90 % sweet copper, 7 % iron + aluminum (hardened)
• rings: stainless steel
• ring diameter: 70 x 130 mm
• mouthpiece: double broken

Care instructions

• clean under running water after every ride
• dry with a towel

Size guide

• if a well-fitting bit is already available, this can be used as a reference for the correct size
• alternatively, measure the width of the horse's mouth: place a bit ruler or a soft string in the mouth at the later bit position
• mark the ends and then measure the distance
• the bit width should be chosen so that the rings are just outside or slightly above the corners of the mouth
• if the bit is too narrow, it can cause pressure points
• if the bit is too wide, it can slip sideways
• in the case of bits with freely movable rings, there should be about 1 cm clearance on each side so that the rings can move freely without pinching the lips